Lathem ATX User Manual download pdf (Page 9)

ATX Installation and User’s Guide

Page 4

button for 4 seconds to begin WWVB reception again and move the

ATX to another location with a clear line of site toward the sky.

Once the ATX receives the WWVB signal do not change its location.

Because it must continue receiving WWVB signals, the ATX must

be installed in the same area where WWVB signals are first

received.

Once the WWVB signal is received, the indicator

will stop

scrolling.

(To verify the WWVB signal has been received in the

past 24 hours press the RECV button for 2 seconds and release.

The

indicator will flash 4 times indicating the signal has been

received or 5 times if no reception has occurred).

7. Press and release the TRNS button on your Master ATX to begin

transmitting to AirTime Wall clocks and other ATX devices. The

TRNS flashing in the display confirms the transmissions.

The ATX will transmit for one hour, allowing you to setup and install

your AirTime wall clocks and Repeaters.

Insert the batteries into your wall clocks and Repeater ATXs (if

applicable). Press and release the reset button on the back of

the AirTime wall clocks or the front of the Repeater ATXs to

start

receiving the signal from the Master ATX.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

Lathem ATX User Manual Page 9