Lathem Airtime AT-DDC4 User Manual download pdf (Page 8)

Page 6

Double Mount – Wall

The AT-DDC requires optional mounting kit (SAM0625)

Tools required for mounting the clock:

Flat blade screwdriver

Phillips head screwdriver

15/16" open end wrench

The double wall mount plate attaches to a double or single gang box

installed securely in the wall. Required wiring should be available

through the gang box at time of installation.

» Remove the two chase nipples from the mounting plate posts.

» Secure the mounting plate securely to the gang box with the

proper screws. (not supplied)

Note: The long dimension of the mounting plate must be perpendicular

to the ground to assure proper alignment of wall clocks.

Mounting - Wall

» Remove the two phillips head screws from the left and the

right end caps of the two DDC4 clocks and remove. Slide the

front panel assemblies out of the cases and set aside.

» Place the two DDC4 clocks back to back and secure by inserting

a #10 screw through the two key holes and the two lower

mounting holes using lock washers and nuts supplied with the

mounting kit.

» Attach the modified end cap to the end of the clocks that will

be attached to the wall mount plate using the original end cap

screws.

» Align the holes of the end cap support plate with the holes in

the modified end cap and secure with 4 #6 phillips head screws

(supplied)

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Lathem Airtime AT-DDC4 User Manual Page 8