Lathem AirTime AT-MSX User Manual download pdf (Page 4)

Installation & User’s Guide

Page 2

Install Steps

Important: Before installing the AT-MSX, verify that an AirTime

Transceiver is installed and properly transmitting. You should

manually initiate the transmission of the AirTime signal by

pressing the TRANS button on the front of your transceiver.

1. Mount the AT-MSX within range of an AirTime transceiver’s

signal. It is important that the AT-MSX be mounted upright

as described to achieve maximum antenna reliability.

» After locating where the AT-MSX will be mounted, mark the

two spots for the mounting screws using the enclosed template.

» Drill a 5/16" hole at each mark

» Insert wall anchors and tap flush to the wall with the hammer.

» Insert both screws into wall anchors leaving 1/8" exposed.

» Align both keyholes on case back and slip over the two screws.

1 2 3 4 5 6 7

No comments

Lathem AirTime AT-MSX User Manual Page 4