Lathem ATX User Manual

Model ATX AirTime Wireless Wall Clock Transceiver Installation & User's Guide Copyright © 200

ATX Installation and User’s Guide Page 5 9. Install the Master ATX: Install the ATX in the same location where the WWVB signal was received

ATX Installation and User’s Guide Page 6 Repeater Mode (Used in Multiple ATX Installations) In Repeater mode, the ATX receives time signals from anot

ATX Installation and User’s Guide Page 7 6. When the signal is received from the “Master”, the term “LINK” will display and the time and date

ATX Installation and User’s Guide Page 8 Glossary of Definitions: Selection of Mode Select the MASTER mode or REPEATER mode by using the MODE switch.

ATX Installation and User’s Guide Page 9 How to access Setup Modes 1. Select the setup mode to enter by pressing the SET button for the period of tim

ATX Installation and User’s Guide Page 10 Additional Definitions Automatic Interference Prevention Function Use this function to automatically c

ATX Installation and User’s Guide Page 11 Power Requirements Cylindrical lithium battery (2 batteries) or Optional AC adapter Specifications of option

ATX Installation and User’s Guide Page 12 reception indicator scrolls? A. Make sure you selected “Master” mode, then move the ATX closer to

ATX Installation and User’s Guide Page 13 Q. How do I synchronize my AirTime wall clocks? A. Press the TRANS button on the ATX. You will see T – TR

ATX Installation and User’s Guide Page 14 Trademark / Copyright AirTime, Lathem and the Lathem logo are registered trademarks of Lathem Tim

Table of Contents Introduction ... 1 LCD Display – Time, Date, Time Zone an

ATX Installation and User’s Guide Page 15 One-Year Limited Warranty Lathem warrants the hardware products described in this guide against defects in m

ATX Installation and User’s Guide Page 1 Introduction The ATX (AirTime Transceiver) is a user-installable, battery-operated radio-frequency

ATX Installation and User’s Guide Page 2 Transmitting “TRNS” When flashing, indicates the ATX is transmitting an AirTime signal Receiving “RECV” When

ATX Installation and User’s Guide Page 3 AirTime wall clocks and ATX Repeaters. The WWVB signal strength indicator indicates the strength

ATX Installation and User’s Guide Page 1  Start Here Master Mode !! IMPORTANT !! This AirTime System is designed to provide highly accurate

ATX Installation and User’s Guide Page 2 3. Set Time Zone: Press and release the Set button for less than 1 second. The Time Zone will flash on th

ATX Installation and User’s Guide Page 3 4. Use the Up or Down buttons to Enable (EN) or Disable (DI) the Daylight Savings Time function. If enabled,

ATX Installation and User’s Guide Page 4 button for 4 seconds to begin WWVB reception again and move the ATX to another location with a clear line of